Doppler Shift is the change in the perceived frequency relative to the transmitted frequency. The Doppler shift is dependent on the insonating frequency, the velocity of moving blood, and the angle between the sound beam and direction of moving blood.
Doppler equation:
Doppler shift frequency: fD = fr - f0 = 2f0v/c
Where fD is the Doppler shift frequency = the difference between transmitted and received frequencies.
Ultrasound system use the following equation:
Doppler shift frequency with incident angle: fD = 2f0v/c cosØ
Where f is the transmitted frequency, v is the blood velocity, c is the speed of sound in tissue, cosØ is the Cosine of the blood flow to beam angle.
The Doppler angle (theta) is the angle of incidence of the beam upon the object. If the beam is parallel to the flowing blood, the angle theta is zero, and the determination of flow is most accurate. If the angle of incidence is greater, the results are less reliable. Doppler shift results with an angle greater than 20° should not be used for the calculation.

See also Doppler Interrogation Frequency, Zero Crossing Detector, Doppler Effect, Doppler Ultrasound and Motion Discrimination Detector.

The Doppler spectrum indicates how the echo power is distributed according to the Doppler shift frequency. The Doppler shift frequency is directly related to the radial velocity of the scatterer.

See also Modal Velocity, Doppler Effect and Doppler Ultrasound.

The Doppler velocity signal refers to a signal whose voltage is proportional to the Doppler frequency shift, obtained by a frequency-to-voltage conversion of the Doppler signal.

See also Autocorrelation, Temporal Mean Velocity, Doppler Effect, Doppler Ultrasound and Maximum Venous Outflow.

Plethysmography implies volume measurement procedures including air, impedance or strain gauge methods. Vascular plethysmography is a non-invasive measurement of the systolic blood pressure of a leg compared with that of an arm to determine circulatory capacity. The test is usually performed to rule out vascular blockages in the arms or legs, usually in combination with Doppler ultrasound.

See also Oculoplethysmography, and Pulse Volume Recording.

In power mode the amplitude (power) of color Doppler signals is displayed, regardless of the velocity. Power does not have negative values and is independent of sampling frequency. An aliasing artifact does not occur in power mode images. Caused by plotting the quantity enhanced by echo contrast agents in a power map, power mode is often used in contrast Doppler ultrasound examinations.
Also known as energy mode.